Replacing The Lamp; Closing The Door - AEG S18C5T Benutzerinformation

46 www.aeg.com
Problem
DEMO appears on the dis‐
play.
A or
shown instead of numbers
on the temperature display.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.

8.2 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
Possible cause
There is no cold air circula‐
tion in the appliance.
The appliance is in demon‐
stration mode.
Temperature sensor prob‐
or symbol is
lem.
Solution
Make sure that there is cold
air circulation in the appli‐
ance. Refer to "Hints and
Tips" chapter.
Keep the OK key pressed for
approximately 10 seconds
until a long sound is heard
and the display turns off for
a short time.
Contact the nearest Author‐
ized Service Centre (the
cooling system will continue
to keep food products cold,
but temperature adjustment
will not be possible).

8.3 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to installation instructions.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.