Replacing The Lamp; Closing The Door - AEG RDB424E1AW Benutzerinformation

Problem
Water flows inside the refrig‐
erator.
Water flows on the floor.
Temperature cannot be set.
The temperature in the appli‐
ance is too low/too high.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.

8.2 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
Possible cause
Food products prevent the
water from flowing into the
water collector.
The water outlet is clogged.
The melting water outlet is
not connected to the evapo‐
rative tray above the com‐
pressor.
The Super Freeze function is
switched on.
The temperature is not set
correctly.
The door is not closed cor‐
rectly.
The food products' tempera‐
ture is too high.
Many food products are stor‐
ed at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
The Super Freeze function is
switched on.

8.3 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation" chapter.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
ENGLISH
Solution
Make sure that food prod‐
ucts do not touch the rear
plate.
Clean the water outlet.
Attach the melting water out‐
let to the evaporative tray.
Switch off the Super Freeze
function manually, or wait
until the function deactivates
automatically to set the tem‐
perature. Refer to "Super
Freeze function" section.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door"
section.
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces‐
sary.
Refer to "Super Freeze func‐
tion" section.
17