Welding With Mig / Mag Method In Synergic (Automatic) Mode - Lincoln Electric POWERTEC 280C PRO Bedienungsanleitung

thickness set the proper welding voltage with
switches [3] and the wire feeding speed with WFS
knob [7]. The chart below can be useful for welding
setting selection:
Obeying the appropriate rules, you can begin to
•
weld.
Welding with MIG / MAG method in
Synergic (automatic) mode
To begin welding process with MIG/MAG method in
synergic mode you should:
Insert the plug of input supply cable into the main
•
socket.
Switch ON the machine with the "Power Switch" [1]
•
(it should light on).
Insert the electrode wire into the torch using "Cold
•
Inch" switch [5].
Check gas flow with "Gas Purge" switch [5].
•
Set the knob of the choice wire diameter selection
•
[16] in the position corresponding to the diameter of
the used wire.
Set the knob of the choice welded material and gas
•
mixture [17] in the position corresponding to the
used material.
If the selected welding process does not have
synergic mode, three horizontal dashes will appear
on the display "A".
According to the selected welding mode and
•
material thickness, set the proper welding voltage
through the "Welding Voltage Changing Switches"
[3].
For synergic welding
automatically select the proper wire feeding speed
for each position of the "Welding Voltage Changing
Switches" [3]. The automatic speed value can be
adjusted in the range of the ±25% by the WFS
Control Knob [7].
Obeying the appropriate rules, you can begin to
•
weld.
Changing Driving Rolls
The machine is equipped with drive rolls for the wire of
1.0 and 1.2mm (factory default). For others wire sizes,
is available the proper drive rolls kit (see chapter
Accessories for ordering the desired kit). Below is the
drive rolls replacement procedure:
Switch off the machine.
•
Release the pressure roll lever [32].
•
WARNING
WARNING
mode the machine
Unscrew the fastening cap [33].
•
Open the protection cover [34].
•
Change the drive rolls [35] with the compatible ones
•
corresponding to the used wire.
For wires with the diameter greater than 1.6mm, the
following parts are to be changed:
The guide tube of the feeding console [36] and
•
[37].
The guide tube of the Euro socket [38].
•
Replace and tighten the protection cover [34] to the
•
drive rolls.
Screw the protection cover by fastening screws [33].
•
Maintenance
For any maintenance or repair operations it is
recommended to contact the nearest technical service
center or Lincoln Electric.
performed by unauthorized service centers or personnel
will null and void the manufacturers warranty.
The frequency of the maintenance operations may vary
in accordance with the working environment where the
machine is placed.
Any noticeable damage should be reported immediately.
Routine maintenance (everyday)
Check cables and connections integrity. Replace, if
•
necessary.
Remove the spatters from the welding gun nozzle.
•
Spatters could interfere with the shielding gas flow
to the arc.
Check the welding gun condition: replace it, if
•
necessary.
Check condition and operation of the cooling fan.
•
Keep clean its airflow slots.
Periodic maintenance (every 200 working hours
but not more rarely than once a year)
Perform the routine maintenance and, in addition:
Keep clean the machine. Using a dry ( and low
•
pressure) airflow, remove the dust from the external
case and from inside of the cabinet.
A-6
WARNING
WARNING
Maintenance or repairs