Guarantee; Disposal - Dometic Travel Power 3.5 Montageanleitung

Guarantee

The resistance between socket connection 4 – 5 should be
– Travel Power 3.5: 2.85 Ω ± 0.1 Ω
– Travel Power 5.0: 2.85 Ω ± 0.1 Ω
– Travel Power 8.0: 7.35 Ω ± 0.30 Ω
➤ Measure the resistance between the generator housing and each of
the cables 1 through 5 (fig. e, page 9). The resistance should be
more than 1 MΩ for a sufficient insulation between winding and
ground.
➤ If any resistance value is incorrect the generator must be exchanged.
➤ However, if all measurements are correct check carefully the shielded
cable, because a short-circuit or a break in the cable is likely.
➤ Measure at both ends the resistance of each cable part to recognise
any short-circuit.
➤ Twist and turn the cable to see any possible damages.
14 Guarantee
The statutory warranty period applies. If the product is defective, please
contact your retailer or the manufacturer's branch in your country (see the
back of the instruction manual for the addresses).
For repair and guarantee processing, please include the following docu-
ments when you send in the device:
 A copy of the receipt with purchasing date
 A reason for the claim or description of the fault
15

Disposal

➤ Place the packaging material in the appropriate recycling waste bins
wherever possible.
If you wish to finally dispose of the product, ask your local recycling centre
M
or specialist dealer for details about how to do this in accordance with the
applicable disposal regulations.
40
Dometic Travel Power
EN