Ferm AGM1096P Betriebsanleitung Seite 8

Fig. A
1. Spindle lock button
2. Allen screw
3. Protection guard
5. On/Off switch
6. Side handle connection point
7. Side handle
Fig. B
8. Spindle
9. Mounting flange
10. Wheel disc (not included)
11. Clamping nut
12. Spanner
Fig. C1 & C2
Protection guard for grinding
Assembly
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
Assembling the protection guard (Fig. C)
• Place the machine on a tablewith the spindle
(8) facing upwards.
• Place the protection guard (3) over the
machine head as shown in Fig. C making sure
the ridges on the protection guard fall into the
notches of the machine head.
• Turn the protection guard counter clockwise and
secure the guard by tightening the screw (14).
Never attempt to remove the guard.
Mounting and removing the disc (Fig. B)
• Always use suitable wheel disc for this
machine with diameter Ø 125mm and a bore
from 22.2 mm the thickness of the wheel disc
should be 6 mm for wheel disc for grinding and
3 mm for wheel disc for cutting, the mounting
wheel disc may not touch the safety guard.
Mounting
• Place the machine on a table with the
protection guard (3) facing upwards.
• Mount the flange (9) onto the spindle (8).
• Place the wheel disc (10) onto the spindle (8).
• Keep the spindle lock button (1) pressed and
firmly tighten the clamping nut (11) onto the
spindle (8) by using the spanner (12).
8
Removing
• Place the machine on a table with the
protection guard (3) facing upwards.
• Keep the spindle lock button (1) pressed and
loosen the clamping nut (11) using the spanner
(12).
• Remove the wheel disc (10) from the spindle (8).
• Keep the spindle lock button (1) pressed and
firmly tighten the clamping nut (11) using the
spanner (12).
Mounting the side handle (Fig. A and B)
• The side handle (7) can be screwed into one of
the three side handle connection point (6).
3. OPERATING
Make sure that the work piece is properly
supported or fixed and keep the supply
cord routing away from the work area.
Switching on and off (Fig. A)
• To switch the machine on, keep the lock-off
button (17) pressed and then press the On/off
switch (5).
• To switch the machine off, release the On/off
switch (5).
Hold the machine away from the work piece when
turning it on and off because the wheel disc could
damage the work piece.
• Clamp the work piece firmly or use another
method to ensure that it cannot move while
working.
• Check the discs regularly. Worn wheel discs
have a negative effect on the machine's
efficiency. Change to a new wheel disc in good
time.
• Always first turn the machine off after use
before removing the plug from the socket.
Deburring (Fig. E)
An angle of inclination of 30º to 40º will give the
best results when deburring. Move the machine
back and forth using light pressure. This will
prevent the work piece from discolouring or
becoming too hot and will avoid making groves.
Never use abrasive cutting discs for
deburring work!