Details Of The Control Panel (Quick Start - Alarm) - Teuco HYDROTOP Hydrosilence Gebrauchsanweisung

DETAILS OF CONTROL PANEL AND DISPLAY
Whirlpool
ON/OFF button
LED
Blinking Led: Indicates reception of signals from Remote
Control (see Remote Control)
WHIRLPOOL QUICK START
Once the system has been powered up, the whirlpool function can be activated by pressing a single
button at the control panel. The function maintains the settings most recently stored (see WHIRLPOOL).
To start the whirlpool, press the "HYDRO" button.
The whirlpool starts and the display shows:
• The exact time.
• The temperature of the water in the tub.
The duration of the whirlpool session
•
(TIMER) in minutes.
• Confirmation that the Whirlpool is in
operation.
To make adjustments, use the remote control (see
Remote Control).
When the whirlpool has finished, the system shuts
off and the display reverts to STAND-BY.
DISINFECTION of the system is not carried out
(see DISINFECTION).
To cut the session short, press HYDRO a second time or use the remote control (see Remote
Control: Preliminary Operations); the system shuts off and the display reverts to STAND-BY.
HYDROTOP - Hydrosilence
Display
Shows messages
Infrared receiver
o
15 36 C 20:30
WHIRLPooL
Display indicating
Whirlpool in progress
20:30
Display in STAND-BY mode
EN
ALARM
ON/OFF button
7