Conditions Of Installation And Normal Operation - FPZ SCL K09R MD-GOR Betriebsanleitung

9.2

CONDITIONS OF INSTALLATION AND NORMAL OPERATION

Startup and operation must occur only under the following conditions:
•
The unit must be completely assembled and intact, i.e. not damaged or tampered with.
•
The silencers must be properly connected to the system piping.
•
The machine must be securely fixed in place.
•
The motor must be connected to a suitable control panel.
•
If installed outdoors, protect the unit against the sun and weather.
Risk of injury due to shearing, crushing and catching
During work on the unit there are risks of injury due to shearing, crushing or catching.
Therefore it must be carried out by technicians who handle and install the machine, taking the necessary safety measures and
following the instructions given in this manual.
Danger due to escaping process fluids
Danger due to overpressure with sudden release of process fluids (injury to the skin and eyes)!
Start the machine only if properly connected.
Danger due to electricity
Work on the electrical equipment must only be carried out by qualified and authorised electricians!
Before starting work on the unit or system, take the following precautions:
- disconnect the mains power;
- open the terminal box only after making sure the power is disconnected;
- take steps to prevent the power from being reconnected.
Danger of suction
Danger due to negative pressure: sudden drawing in of hair and clothing. Start the machine only if properly connected.
Danger due to seizing of the impeller caused by performance values being exceeded
Use the blower, making sure the operating conditions comply with the values given in the SPECIFICATIONS.
Never operate the unit, even temporarily (if not foreseen), with the inlet and/or outlet port closed.
Install a limiter valve or equivalent circuit that can prevent excessive vacuum and/or overpressure and that enables compliance with
the values given in the SPECIFICATIONS in this manual and the RATING DATA.
Turn the unit off immediately in case of any abnormal impeller noise! Then schedule maintenance.
FPZ-MI-K MD-GOR/GVR-EU-R00-15 33 / 118