Warnings Concerning Installation And Normal Operation - FPZ K07-MS Betriebsanleitung

- the Atex labelling of the machine and correspondence to the classification of the zone, in accordance with Directive 1999/92/CE
- these instructions together with the instructions of all the other equipment comprising the plant;
- the warning signs and information present on all the equipment of the plant;
laws and regulations plus any specific requirements in relation to the plant in which the blower must operate.
-
Use which does not conform to intended use may cause serious injury and even death!
The unit may be started up only:
•
in conformity with the purposes, transport and handling stated in "INTENDED USE".
•
complying with the values shown in the "CHARACTERISTIC DATA" table.
• All transportation, assembly, installation, start up and
maintenance operations must be done exclusively by
qualified personnel, hereafter
Technicians. Technicians
instruction, experience and knowledge of standards,
regulations, accident prevention procedures
operating and service conditions to enable them to
carry out all the work necessary, while being aware of
and avoiding any possible danger and/or damage.
• Follow the instructions regarding handling, installation,
and start-up listed in the following paragraphs. These
operations must be done wearing suitable personal
protection equipment (PPE).
• Do not wear loose fitting clothing, with long strings of
other objects that could get entangled. Tie back long
hair.
7.2.1

WARNINGS CONCERNING INSTALLATION AND NORMAL OPERATION

Danger of injury due to shearing, crushing, entanglement!
During work on the unit there are risks of injury due to shearing, crushing or entanglement!
For this reason, work must be done by Technicians who handle and install the machine using the necessary safety precautions and
following the instructions in this manual.
Danger due to electricity!
Improper conduct may cause serious injury and even death!
Work on electrical equipment must be done exclusively by authorised qualified electricians!
Before starting work on the unit or plant, it is necessary to take the following precautions:
- cut off electrical power at the mains.
- open the terminal box only after making sure that there is no electrical voltage;
- take steps to prevent the mains from being turned back on.
Danger due to process fluids which can spew out!
Danger due to overpressure with sudden discharges of process fluids (injury to the skin and eyes)!
Start up the machine only if it is correctly connected.
Danger due to suction!
Danger due to vacuum: hair and clothes can be sucked in suddenly! Start up the machine only if it is correctly connected.
Chemical Hazard
Presence of cooling oil generally classified as not dangerous.
referred to as
have the training,
and
27 / 96