Hilti WSC 85 Original Bedienungsanleitung Seite 21

Power output
No-load speed
Speed under load
Cutting speed under no load
Cutting speed under load
Cutting depth at 0 °
Cutting depth at 45 °
Cutting depth at 60°
Saw blade diameter
Saw blade arbor size
Riving knife thickness (standard)
Weight in accordance with EPTA procedure 01
Protection class
4.2 Noise information and vibration values in accordance with EN 62841
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure.
The data given represent the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools, or is poorly maintained, the data can vary. This can
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the total
working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration, for
example: maintaining the power tool and accessory tools, keeping the hands warm, organization of work
patterns.
Noise information
Typical A-weighted sound power level
Typical A-weighted emission sound pressure level
Uncertainty
Vibration information
Triaxial vibration value when cutting wood (a
Uncertainty (K)
5 Operation
5.1 Removing the saw blade
WARNING
Risk of burning injury. A hot accessory tool, clamping flange or clamping screw and the sharp edges
of the saw blade present hazards.
▶ Wear protective gloves when changing saw blades.
1. Rest the power tool on the ribbing.
2. Lock the spindle by holding the drive-spindle lock button down with one hand.
3. Use an Allen key to slacken the flange screw underneath the motor cover.
4. Use the adjusting lever to set the cutting depth to 0.
5. Use the Allen key to turn the screw counter-clockwise to remove.
6. Remove the clamping flange.
Printed: 07.09.2017 | Doc-Nr: PUB / 5071332 / 000 / 04
)
h
2
WSC 85
1,260 W
4,500 /min
3,100 /min
54 m/s
37.3 m/s
0 mm ...85 mm
0 mm ...60 mm
0 mm ...43 mm
207 mm ...230 mm
30 mm
2 mm
7.8 kg
II
WSC 85
111 dB(A)
100 dB(A)
3 dB(A)
WSC 85
≈ 2.5 m/s²
1.5 m/s²
English 15