Hilti WSC 85 Original Bedienungsanleitung Seite 22

7. Open the pivoting guard.
8. Hold the pivoting guard so that it does not move.
9. Remove the saw blade.
5.2 Fitting the saw blade
CAUTION
Risk of damage Unsuitable or incorrectly fitted saw blades may damage the saw.
▶ Only use blades which are suitable for this saw. Observe the direction-of-rotation arrow on the
saw blade.
1. Rest the power tool on the ribs provided.
2. Lock the arbor by holding the arbor lockbutton down with one hand.
3. Fit the clamping flange to the arbor.
4. Securely tighten the screw.
5. Make sure that the clamping flange is seated correctly.
Note
The riving knife thickness must be less than the kerf width of the saw blade and at least equal to
the saw blade disc thickness.
Gap A must be less than 5 mm (0.2 in).
5.3 Adjusting the cutting depth
1. Release the lock.
2. Set the cutting depth with the lever for the cutting depth.
◁ The cutting depth is shown on the cutting depth scale.
Note
For a clean-edged cut, set cutting depth to the thickness of the material plus 2 mm.
3. Secure the lock.
5.4 Plunge function 4
Note
You can use the plunge function with the saw blade set to any cutting angle.
1. Set the cutting depth. → page 16
◁ Set the cutting depth to 0.
2. Position the saw on the workpiece.
◁ Bring the rear mark on the base plate into alignment with the cutting line.
Note
To reduce the risk of kickback, secure a stop piece to the workpiece directly behind the base plate.
3. Release the cutting depth locking mechanism.
4. Press the saw against the workpiece and against the stop.
5. Switch the power tool on. → page 17
6. Set the cutting depth. → page 16
7. Make the cut.
8. Switch the power tool off. → page 17
9. Wait until the saw blade has stopped rotating.
10. Lift the saw clear.
5.5 Setting the cutting angle
1. Remove sawdust from the base plate.
2. Slacken the clamping screw.
3. Pivot the base plate to the desired cutting angle.
◁ The cutting angle is shown on the cutting angle scale.
16 English
Printed: 07.09.2017 | Doc-Nr: PUB / 5071332 / 000 / 04
3
4
5