Silvercrest Z30342 Bedienungshinweise Und Sicherheitshinweise Seite 6

Use / Cleaning and Maintenance / Disposal
wise direction until it is tight (note the markings
on the device).
Using of the salt
Q
and pepper mill
j
R emove the cover
j
P lease keep the button
the salt and pepper mill. The bulb
base of the salt and pepper mill will then be
simultaneously activated.
Note: Use the mill only when the container
is full and do not leave the mill switched on
4
uninterrupted for longer than 1 minute so that it
does not overheat. After using the mill for one
minute, let it cool down for at least 3 minutes
before switching it on again.
Adjusting the grinding level
Q
j
T urn the adjustable screw
ceive a finer grinding level.
j
T urn the adjustable screw
receive a coarser grinding level (see fig. C).
Note: If you can no longer turn the grinder
when it is adjusted to very fine, you have to se-
lect a coarser setting. If the grinder still does
not turn, it may be clogged up. Release the ad-
justment screw and take out the grinder.
7
Clean it, place it back in position and then
retighten the adjustment screw
Recharging the salt / pepper
Q
mill again
j
R emove the cover
j
P lace the charging station
level surface. Insert the adaptor
ing station and then connect it to a socket.
6
j
Place the salt / peppermill with the Silvercrest
logo facing towards the front on the charging
station in order to start the charging pro-
6
cess. The charging time is approximately 3
hours.
6 GB/IE
.
5
pushed to activate
2
on the
8
clockwise to re-
7
anticlockwise to
7
.
7
.
5
onto a stable and
6
into the charg-
12
Note: The red LED light on the mill will shine
during the charging process. It will go out when
the rechargeable batteries have been completely
recharged.
Replacing the light
Q
Note: Remove the rechargeable batteries before
replacing the light bulb in order to avoid switching
the salt / pepper mill on by accident. Only use light
bulbs of the same type and the same wattage as
you could otherwise damage the mill.
j
T urn the salt / pepper mill around so that the
grinder and the lighting
j
C arefully remove the light bulb from the bulb
socket.
j
I nsert the new light bulb into the bulb socket.
Cleaning and Maintenance
Q
j
T he device should only be cleaned on the out-
side with a soft dry cloth.
j
U nder no circumstances should you use liquids
or detergents, as these will damage the device.
Disposal
Q
The packaging is made entirely of recy-
clable materials, which you may dispose
of at local recycling facilities.
Contact your local refuse disposal authority for more
details of how to dispose of your worn-out product.
To help protect the environment, please
dispose of the product properly when it
has reached the end of its useful life and
not in the household waste. Information
on collection points and their opening
hours can be obtained from your local
authority.
are at the top.
8