SPORTSTECH F66 Benutzerhandbuch Seite 44

9.2. Error and self-inspection
Treadmill gives out the following error codes if anything is wrong.
Please contact the professional service people if it happens.
E-01
E-02
E-03
E-04
E-07
No need to self-inspect unless special situation.
If necessary, please do it under the instruction of professional technical people or sales
because of the high voltage.
a) Turn on the red power switch and make sure again the safety key is inserted.
(if absent, please insert the key)
b) Press the "start" and "speed +" key at the same time until the safe key button has been turned on
as the direction on the button. then press the "mode" key (??)
c) after the LED display finished, then press the "mode" key again.
d) the treadmill runs from the lowest speed to highest speed , meanwhile, the incline is also from
lowest to highest. Then treadmill stopped.
NOTE: The whole self-inspection process takes about 5 minutes
Undervoltage or problem of inverter
Overcurrent or the problem of inverter
Overload, or the problem of inverter
Overheating or the problem of inverter
Safety key Off
19