BestWater JUNGBRUNNEN 22-00 ULTIMATE Gebrauchsanleitung Seite 30

Maintaining the BestWater System
En
First unscrew the screwcap on the
pipe.
Remove the pipe of the faucet.
NOTE: There may still be water
inside the faucet that can drip
out when removing the pipe.
Once the faucet has been disas-
sembled you will find the following
pieces: pipe with O-ring seals, the
vitalising stainless steel coil, and
a support ring. These parts will be
placed back into the faucet after
disinfection.
Pour some disinfecting gel into the
underside of the pipe.
58
Insert the pipe cleaner provided
into the pipe.
Push the pipe cleaner through to the
end of the pipe. Insert and withdraw
the pipe cleaner numerous times
back and forth. This ensures that
the disinfectant is spread evenly
throughout the pipe.
Reset the pipe and the vitalising
stainless steel coil, with seal, back
into the faucet socket. Then screw
the screwcap finger-tight back onto
the pipe socket.
Let about 7 - 10 litres of water flow
through the faucet to rinse out the
remaining disinfectant.
Jungbrunnen 22-00
Height x width x depth
Weight
Minimum water flow pressure
Maximum water flow pressure
Water production in 24 hours
Water production per minute
Permeate-retentate ratio
Untreated water consumption/min.
Water connection
* The flow pressure must be at least 2.5 bar and may not exceed 7.0
bar of overpressure. If the pressure is greater than 7.0 bar of over-
pressure, a pressure reduction valve must be installed.
** The consumption data may deviate from the values above depen-
ding on water pressure, water hardness, water flow temperature,
and room temperature.
A corner valve with a 3/4" screw joint
is required. If one is not available,
the BestWater system may only be
connected to the mains water system
by an authorised installer.
Technical Info
460 mm x 300 mm x 140 mm
approx. 5.4 kg
2.5 bar*
7.0 bar*
150 litres**
0.1 litres**
1:2.5**
approx. 0.4 litres**
3/4"
The BestWater system may not be
connected to a mains water line via ad-
ditional check valves.
En
59