BestWater JUNGBRUNNEN 22-00 ULTIMATE Gebrauchsanleitung Seite 22

Setting Up and Connecting
En
Outflow
Socket
Work plate
Large plastic disc
Subordinate disc
Nut
Connector IT
Plastic hose 1/4"
Please note that the maximum hose
length for this system is 5m for a 1/4"
hose.
No additional fittings may be installed
between the device and the faucet (e.g.
depressurisers, check valves, etc.)!
42
To Jungbrunnen 22-00
ULTIMATE
Screw the large plastic disc, the
subordinate disc, and the nut onto
the faucet thread.
Use a box wrench to fasten the nut.
Now screw the connector with inter-
nal thread (IT) onto the faucet th-
read.
The connector IT should only be
screwed onto the faucet thread fin-
ger-tight.
Should the connector IT be ap-
plied with a box wrench, this will
absolutely destroy the connector
IT.
Setting Up and Connecting
The drain
The drain of the BestWater system
can be applied to all 40 - 50 mm
thick plastic hoses with ease. Figure
out where you will set up the drain
clamp before installation.
Drain clamp Ø 40 mm
Foam rubber
seal
Hole Ø 7 mm
Note that the water drain should be
visible once completely installed.
After you have determined where
the drain clamp will be installed,
drill a hole above the air trap with a
7 mm drill bit. Remove the residue
after drilling.
En
43