Programming Additional Transmitters; Deleting Transmitters - Becker Centronic VarioControl VC260 Montage- Und Betriebsanleitung

Programming additional transmitters

Note
In addition to the master transmitter, up to 15 fur‐
ther transmitters can be programmed in the VC260.
Press the programming button of the master transmitter for 3 sec‐
onds.
[ The shading solution shifts to confirm.
Now press the programming button of a new transmitter which has
not yet been programmed in the VC260 for 3 seconds. Doing so ac‐
tivates the programming mode of the VC260 for a new transmitter
for 3 minutes.
[ The shading solution shifts to confirm.
Now re-press the programming button of the new transmitter you
wish to program for 3 seconds.
[ The shading solution shifts to confirm.
Æ The new transmitter is now programmed in.
Deleting individual transmitters
Press the programming button on the master transmitter for 3 sec‐
onds.
[ The shading solution shifts to confirm.
Now press the programming button of the transmitter to be deleted
for 3 seconds.
[ The shading solution shifts to confirm.
Then re-press the programming button of the transmitter to be de‐
leted for 10 seconds.
[ The shading solution shifts to confirm.
Æ The transmitter is now deleted from the VC260.
30

Deleting transmitters