Becker Centronic VarioControl VC260 Montage- Und Betriebsanleitung Seite 31

Deleting all transmitters (except the master transmit‐
ter)
Press the programming button on the master transmitter for 3 sec‐
onds.
[ The shading solution shifts to confirm.
Re-press the programming button on the master transmitter for 3
seconds.
[ The shading solution shifts to confirm.
Re-press the programming button on the master transmitter for 10
seconds.
[ The shading solution shifts to confirm.
Æ All transmitters (except the master transmitter) have been de‐
leted from the receiver.
Overwriting the master
Press the programming button on the VC260 for 3 seconds.
[ The programming indicator lamp (green) shows the device is
ready for programming.
[ The VC260 goes into the programming mode for 3 minutes.
Now press the programming button of the new master transmitter
for 10 seconds.
[ The shading solution shifts to confirm.
Æ The new master transmitter has now been programmed and the
old master transmitter overwritten.
31