Deleting Transmitters - Becker Centronic VarioControl VC470-II Montage- Und Betriebsanleitung

Assembly and Operating Instructions
a) Deleting transmitters individually
Note
The master transmitter programmed under "programming the radio
control" cannot be deleted. It can only be overwritten (see "overwrit-
ing master").
1. Press the programming button on the master transmitter for 3 seconds.
The curtain will "nod" to confirm.
2. Now press the programming button of the transmitter to be deleted for 3 sec-
onds.
The curtain will "nod" to confirm.
3. Then press the programming button of the transmitter to be deleted for a
further 10 seconds.
The curtain will "nod" to confirm.
The transmitter is now deleted from the VC470-II.
b) Deleting all transmitters (except master transmitter)
1. Press the programming button on the master transmitter for 3 seconds.
The curtain will "nod" to confirm.
2. Press the programming button on the master transmitter for a further 3 sec-
onds.
The curtain will "nod" to confirm.
3. Press the programming button on the master transmitter for a further 10 sec-
onds.
The curtain will "nod" to confirm.
All transmitters (except master transmitter) have been deleted from the receiver.
26
Deleting transmitters