Programming The Transmitter - Becker Centronic VarioControl VC260 Montage- Und Betriebsanleitung

Programming the transmitter

Readying the VC260 for programming
Press the programming button for 3 seconds.
The programming indicator lamp (green) shows the device is ready
for programming.
The VC260 goes into the programming mode for 3 minutes.
Programming the master transmitter
Note
The master transmitter refers to the very first trans‐
mitter programmed in a receiver. In contrast to sub‐
sequently programmed transmitters, the master
transmitter enables, among other things, the setting
of limit positions (for drives with integr. radio receiv‐
er) and the programming or deleting of further
transmitters. Any transmitter that has separate UP,
STOP, DOWN buttons and a programming button can
be a master transmitter.
If a master transmitter is already programmed in the
receiver, press the programming button on the
transmitter for 10 seconds.
Press the programming button of the transmitter for 3 seconds
whilst in programming mode.
[ The shading solution confirms programming with a nodding
movement, i.e. the shading solutions moves a few centime‐
tres before reversing the same distance. This movement will
hereafter be referred to as "shifting".
Æ The programming process is now complete.
29