Configuration Of The Devices - Comelit MT SB 02 Technisches Handbuch

GROUP S.P.A.

CONFIGURATION OF THE DEVICES

Programming telephone Art. 2408W/A
• Each telephone in the system is identified by means
of its own code. This code must be set by means
Push-button programming with audio Art. 1602 group and modules Art. 3323/3, 3323/4 and 3323/6
1. Connect the terminal boards of modules Art. 3323/3, 3323/4
and 3323/6 together and with the terminal board of the
Art. 1602 group using the special cables. Insert the modules
Art. 3323/3, 3323/4 and 3323/6 on the relative terminal boards
(figure 1).
2. On the terminal board of module Art. 4660 or Art. 1602
connect the power supply to ~~ , connect PR to -- and move
P/O from OCC to V+ (figure 2) using the jumpers present on
the terminal board itself. Connect the terminal board to module
Art. 1602 assembled as shown previously. (Warning - modules
Art. 3323/3, 3323/4 and 3323/6 to be programmed must
already be positioned) (figure 2).
NOTE: for connection between the terminal board and module
Art. 1602, it is possible to use the cable Art. 3309, available
as an optional accessory (figure 3) during the programming
stage.
3. Set the Dip switches located on the rear of the audio module
with the same code assigned to the telephone or monitor
according to the correspondence described in the
programming table on page 11.
4. Press the push-button to be associated with the telephone call.
A confirmation tone signals that programming has taken place.
5. On completion of programming, put the jumpers back into their
initial positions, PR on PR and P/O on OCC.
Setting main or secondary external unit.
Modules Art. 1602 normally function as main external unit
(timed engaged signal). To set them as secondary external
unit (engaged signal active for the whole time the riser is in
use), it is necessary to put all the Dip switches of the selector
to ON.
MT SB 02 10
of the Dip switches on the telephone card or on the bracket
(see figures).
Figure 1
Figure 2
Art. 3309
Figure 3