Installation Instructions - Climadiff CLE7 Gebrauchsanweisung

This appliance meets the requirement of the following European Directives, and notably
complies with the following standards:
•
2011/65/EU (ROHS)
•
2006/95/CE on electrical safety
•
2004/108/CE on electromagnetic compatibility
•
643/2009/CE relating to energy labels

4. INSTALLATION INSTRUCTIONS

Before using this appliance
• Remove the exterior and interior packing.
• Check to be sure the following parts are included: CLE7, 6 wire shelves and 1 instruction manual.
• Before connecting the appliance to the power source, let it stand upright for approximately 24 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
• Place your appliance on a floor that is strong enough to support the appliance when it is fully loaded.
To level your appliance, adjust the front feet at the bottom of the appliance.
• Keep the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption.
Extreme cold or hot ambient temperatures may also cause the appliances not to perform properly.
• Adequate ventilation is required, do not block the front air outlet.
• Not designed for placement in adage or basement.
• The appliance is for indoor use only.
• In order to reduce save energy consumption, place your cabinet at where the temperature is
between 20-25°C, and there should be space to allow air to flow around the cabinet, so the heat
produced by condenser can be eliminated in time.
CAUTION: please keep the appliance away from substance, which can cause ignition.
Built-in installation
Your appliance can be used as built-in unit, please follow below measurements if you wish to install
your appliance in a built-in cabinet:
18