Maintenance; Troubleshooting - Climadiff CLE7 Gebrauchsanweisung

6. MAINTENANCE

Before cleaning your appliance (something that should be done regularly), disconnect it by removing
the plug or by pulling the fuse on the circuit.
Before using your appliance for the first time and regularly after that, we recommend that you clean the
inside and outside (front, side and top) with warm mixed with a gentle cleaning product. Rinse with
clean water and allow to dry before reconnecting. Do not use solvents or abrasives.
When the appliance is switched on for the first time, there may be a residual odour. In that case, runt
the appliance empty for a few hours at the coldest possible temperature. The cold will kill any odours.
IMPORTANT: if the power cord is damaged, it must be replaced by a qualified professional in
order to avoid any risk of injury.
CAUTION: unplug the appliance before carrying out any maintenance or repair work.
7. TROUBLE SHOOTING
You can solve many simple problems with your appliance. Try the suggestions below to see if you can
solve the problem before calling service center.
PROBLEM
Appliance not running
Appliance is not cold enough
No interior light
The appliance is too noisy
The door will not close properly
LED could not display
LED display error
The fans are not running
POSSIBLE CAUSE
•
Check the voltage of the installation
•
Check your circuit breaker
•
Check if fuse has blown
•
Check the temperature control setting
•
Check if ambient temperature is too high
•
The door is being opened too frequently
•
The door is not properly closed
•
The door seal is not sealing properly
•
Insufficient free space around the appliance
•
Contact after-sales service
•
Check that the appliance is level
•
Check that a piece of paper or part of the
packaging has not remained trapped inside
•
Check the fan
•
Check that the appliance is level
•
The doors have been reversed and incorrectly
fitted
•
The door seal is in poor condition
•
The feet have moved
•
The control panel is defective
•
Printed circuit board problem
•
Mains plug problem
Call your after-sales service in case of such
problem
•
Poor display quality
•
Temperature does not display
Call your after-sales service in case of such
problem
•
Control panel to be replaced by a qualified
professional
20