Hach Flo-Dar Bedienungsanleitung Seite 19

Figure 14 Vertical alignment of the sensor with SVS
1 Spacer
2 Distance from interior crown of pipe to top of frame
Align the sensor horizontally
The sensor must be aligned horizontally to make sure that the sensor is over the center of the flow. If
the pipe is not level and has a slope of 2 degrees or more, align the sensor to be parallel with the
surface of the water.
Item to collect: Bubble level
1. Remove the paper backing from the bubble level and attach the level to the sensor. Refer to
Figure 12 on page 17.
2. Loosen the clamps and tap the frame into position.
3. Tighten both clamps and measure the frame position to make sure that it is at the correct
position.
Make a final alignment check
The correct vertical and horizontal alignment of the sensor is necessary for accurate measurements.
1. Measure the vertical alignment and make adjustments if necessary. Refer to
vertically – Flo-Dar without SVS
on page 18.
2. Measure the horizontal alignment and make adjustments if necessary. Refer to
horizontally on page 19.
3. Repeat steps 1 and 2 until no further adjustments are necessary.
Optional extended range sensor installation
The extended range sensor
the standard level specifications. Refer to
Use the extended frame
sensor on the wall.
The extended range sensor must be installed at least 457.2 mm (18 in.) above the crown of the pipe
for correct measurements. The extended range sensor has a deadband zone of 431.8 mm (17 in.)
where the sensor is not active.
on page 17 or
(Figure 15) can be used when the pipe or channel depth is more than
Specifications
(Figure 16) instead of the standard frame, or mount the extended range
3 SVS sensor (optional)
Align the sensor vertically – Flo-Dar with SVS
on page 3.
Align the sensor
Align the sensor
English 19