Menu Settings - OHAUS Valor V22PWE1501T Bedienungsanleitung

EN-10

4.6 Menu Settings

The User Menu allows the customizing of scale settings.
Note: Valor 2000W – V22PW does not have these Menus.
4.6.1 Menu Navigation
User Menu:
Menu: C.A.L
Span
Lin
Menu GEO
Items: End
To Enter the Menu Mode
Press and hold Menu until [mMeNU] (Menu) is displayed. When released the first sub-
menu [C.a.l] (Cal) will be shown.
Press Yes to enter the displayed sub-menu or press No to advance to the next.
Selecting a sub-menu will display the first menu item. Press Yes to view the menu
item setting or press No to move to the next menu item. When viewing the setting,
press Yes to accept the setting, or press No to change the setting. When [End] is
displayed, press Yes to return to the sub-menu selections or No to return to the first
item in the current menu. Bold indicates factory default setting.
Note: The Calibration / Menu Mode indicator is displayed when in the Menu Mode.
4.6.2 Cal Menu
Enter this menu to perform calibrations.
• Span [SpaN]
Initiates a span calibration procedure (zero and span).
• Lin [LIN]
(yes, no)
Initiates a linearity calibration procedure (zero, mid-point and span).
• GEO [GEO]
Geographical Adjustment Factor (GEO) is used to adjust the calibration
based on the current location. Settings from 0 to 31 are available with 12
being the default. Refer to table 4-2 to determine the GEO factor that
corresponds to your location.
•
End Cal [End]
Advance to the next menu or return to the top of the current menu.
4.6.3 Mode Menu
Enter this menu to activate modes so they will be available for use with the Mode
button. Weigh mode is always active by default.
• Reset [reset]
Reset the Mode menu to factory defaults.
• Check [CHECk]
Set the sub-mode.
• End Mode [End]
Advance to the next menu or return to the top of the current menu.
M.O.d.E U.n.i.t
Reset kg
Check g
End oz
lb
lb:oz
End
(yes, no)
(no, yes)
(off, on)
Valor™ 2000W Series
E.n.d