Menu Settings - OHAUS Valor 1000W Serie Bedienungsanleitung

EN-6

4. MENU SETTINGS

Press and hold SET until [SEt-Fx] is displayed, where x:
0 = Set checkweigh limits and mode
1 = Set user settings
2 = Restore user settings to factory defaults
3 = Set tare capacity range
4.1 Checkweigh Over and Under Limits
•
Press and hold SET until [SEt-F0] is displayed.
•
Press YES to view the upper limit [000000] (or last value
will illuminate.
•
Press
•
Press YES to confirm, then view the lower limit [000000] (or last value saved).
The Under LED will illuminate.
•
Press
divisions, and less than upper
•
Press YES to confirm, then view the alarm setting [rUn x], where x:
0 = Checkweigh mode is disabled
1 = Checkweigh LEDs are active, beeper will sound when result is outside the
2 = Checkweigh LEDs are active, beeper will sound when result is within the
3 = Checkweigh LEDs are active, beeper is disabled
•
Press
•
Press SET to save and exit.
Note: The measuring unit of the limit values will follow the active unit (see Section
4.2).
Downloaded from www.Manualslib.com
, , to edit the upper limit value (must be less than scale capacity).
, , to edit the lower limit value
Accept range
Accept range
to step through available settings, then press YES to select.
manuals search engine
OHAUS Valor
(must be minimum of 20d scale
limit).
TM
1000W Series
saved). The Over LED