Electrical Unit; Care And Maintenance - AL-KO T 16-102 HDE Edition Originalbetriebsanleitung

Opening and closing the grass box
The grass box is opened or closed by pressing the rocker of
41
the box-locking button.
Function:
Pushing the rocker backwards:
Pushing the rocker forwards:
To reach the end position in question (completely opened or closed), the
box-locking button must remain pressed until the corresponding end
position has been reached.
Intermediate positions of the grass box are possible by letting go of the
box-locking button.
If the grass box is not completely closed, the enginecuts out
when the mowing appliance is switched on.
Emptying the grass box
The grass box can be emptied from the driver's seat.
Attention!
When the grass box is full, an acoustic signal can be heard. The
box should be emptied now at the latest.
Switch the mowing appliance off - acoustic signal goes off.
Emptying the grass box:
41
Press the box-locking button until the grass box has
completely opened.
Hold the grass box by the handle and shake it a number of
times in order to empty it completely.
If the grass box is lifted or removed with the mowing
appliance still switched on, the motor cuts out.
Closing the grass box:
Press the box-locking button until the grass box has
completely closed.
Before switching the mowing appliance on, check whether
the grass box has completely closed.
If the grass box is not completely closed, the engine
cuts out when the mowing appliance is switched on.

CARE AND MAINTENANCE

Cleaning the lawn tractor
In order to work properly, the lawn tractor must be cleaned regularly.
After each use, clean adhering residue from the lawn tractor and the
grass box.
GB
Grass box
Take the grass box off the lawn tractor.
Clean the fabric sack from the outside with a jet of water.
box opens If necessary, also clean the inside of the fabric sack with a brush.
box closes
Housing / engine / transmission
The engine and all the bearings (wheels, transmission, blade bearings
etc.) must not be cleaned with water, in particular not with a
highpressure cleaner.
Any water penetrating into the ignition unit, into the carburettor and the
air filter can cause damage. Water in the bearings can lead to a loss of
lubrication and thus to the destruction of the bearings.
To remove dirt and residue of grass, use a cloth, a hand-held
sweeper, a long-handled brush etc.

Electrical unit

Discharge channel
42
Replacing and resharpening the mowing
blade
At the end of the mowing season always resharpen the mowing blade
or, if required, replace the mowing blade with a new one.
Always have the mowing blade resharpened or replaced by a customer
service centre (measurement of imbalance).
Unbalanced blades will cause the lawn mower to vibrate violently –
risk of accident!
GB 18
Do not clean the electrical unit with water. Penetration
of water into the electrical unit (switch, display, cable,
operating elements etc.) can lead to damage.
The ease of movement of the adjustment of the cutting
height is guaranteed by regular cleaning.
The discharge channel comprises two parts pushed into one
another.
The lower part is firmly attached to the mower housing.The
upper part can be removed for cleaning.
The grass box must be taken off before you can remove the
discharge channel.
Remove screw connection
discharge channel.
Attention!
There is a shim under each screw.
Pull discharge channel out backwards through the rear
wall. Thoroughly clean the upper and the lower discharge
channel.
The discharge channel is put back in reverse order.
on the left and right of the