Setting Options On Model Vehicle; A) Alignment; B) Inclination - Reely ROAD MISSION Bedienungsanleitung


10. Setting Options
on the Model Vehicle

Once you have gotten familiar with the drive characteristics of the model, there is the option to optimize the running
characteristics of the model.
However, the explanations of the correlation between chassis set up settings and driving behaviour are very complex
and would go beyond the scope of these instructions. For this reason, we can only show the setting options provided.
For further information we have to refer you to appropriate specialist magazines as well as comprehensive reference
books on this subject.

a) Alignment

Next to the already mentioned centrally adjustable steering
rods (1), the truck is also provided with two adjustable steer-
ing links (2) on the front axle. With these links and rods the
straight run as well as turning behaviour is adjusted.
With the help of a 5 mm flat spanner which is positioned on
the centre piece (3) the steering rods can easily be turned.
With the left/right thread the length of the complete unit is
changed and is therefore set to the desired value.

b) Inclination

In addition to the adjustable steering links the truck is
equipped with adjustable transverse links (1) on the front
and rear axle, with the help of which you can adjust the
inclination of each wheel separately.
The setting is carried out through changing the length when
turning the right/left thread (2) with the help of a 5 mm flat
spanner.
34
Figure 7
Figure 8