■
The hose must be designed for min . 6 .3 bar
or 125 psi, at least for 150% of the maximum
pressure generated in the system .
■
The tool and the supply hose must be fitted with
a hose coupling that allows the pressure of
the coupling hose to be dispersed completely
during disconnection .
■
DANGER! Avoid contact with an energised line!
This tool is not insulated against electric shock .
WARNING – RISK OF INJURY!
►
Under certain circumstances, high working
pressures can cause kickback to occur . This
can cause hazards due to the continuous
loading .
■
If you are inexperienced with the appliance,
seek training in how to use it safely .
WARNING – RISK OF INJURY!
►
RISK OF PUNCTURE WOUNDS! Do not
treat an injection wound as a simple cut .
A highpressure jet can inject toxins into the
body and cause serious injuries . In the event
of an injection into the skin, seek medical
assistance immediately .
■
The compressed air tool must not be modified in
any way without the manufacturer's approval .
■
Use the compressed air tool only with the speci
fied pressure (6 .3 bar) .
■
The compressed air tool must always be discon
nected from the air supply after use and for as
long as it is not in use .
■
The compressed air tool must not be used if it is
not airtight or if it requires repair .
■
Never connect the compressed air tool with a
compressed air hose that exceeds a pressure
of 6 .3 bar .
■
22
│
GB │ MT
■
Keep work area clean and well lit . Cluttered or
dark areas invite accidents . This enables better
control of the tool in unexpected situations .
WARNING!
►
Have your power tool serviced by qualified
trained personnel using only original spare
parts . This ensures that the safety of the tool
is maintained .
■
Keep children and other persons away from the
tool during operation . Distractions can cause
you to lose control .
■
Dress properly . Do not wear loose clothing or
jewellery . Keep your hair, clothing and gloves
away from moving parts . Loose clothes, jewel
lery or long hair can be caught in moving parts .
■
Put the trigger and the tool away in the case of
an unexpected stoppage of the compressor .
■
Wherever possible, use a condensate separator
or drain the condensate (water) from the hoses
and tubing regularly before and during the use
of the compressed air tools .
■
NOTICE! An undersized compressed air system
will reduce the efficiency of your tool .
■
Please ensure that you have read and under
stood the safety instructions regarding multiple
hazards before installation, operation, repair,
service and replacement of any accessories
and before work near the automatic screwdriv
er . Otherwise, there is a risk of serious physical
injuries .
■
The automatic screwdriver should only be fitted,
adjusted or used by qualified and trained
operators .
PDRS 27 A1