Symbols; Warnings - Quick MILL Evolution '70 Bedienungsanleitung

Mod. Evolution '70 push-buttons
RATING PLATE DETAILS:
1 Manufacturer
2 Model
3 Power supply
4 Mains frequency
5 Registration number
6 Year of manufacture
7 Total machine power
8 Compliance markings
INTRODUCTION
Keep this instruction manual in a safe place. For
any information or difficulties not fully
explained, please contact the service personnel.

1. SYMBOLS

The
identifies all the explanations
of an important nature for
the safety of persons.
Follow these instructions to avoid accidents!
The numerical symbol, numbers or
2
letters refer to illustrations and parts of
the machine such as buttons, lights, etc.
The manufacturer
responsibility for any damages in the
event of:

Uses not in accordance with the intended
purposes;

Alterations made to the power cable;

Alterations made to any component part of
the machine;

Use of non-original
accessories;

Repairs not carried out by an authorised
service centre;
This product meets the labeling
requirements set out in RAEE
Directive (2002/96/CE). The symbol
indicates that this electrical or
electronic product must not be discarded with
normal household waste. PRODUCT CATEGORY
with references to the type of equipment listed
in Annex 1 of the RAEE Directive. This is a
Category 2 product;
appliances".
DO NOT DISPOSE OF THIS PRODUCT IN
CONTAINERS FOR HOUSEHOLD WASTE.
The failure to observe the above mentioned
points voids the guarantee.

2. WARNINGS

warning triangle
assumes no
components or
"Small domestic

The packaging material (plastic bags, polystyrene,
nails, cardboard, etc.) must not be left within the
reach of children as they are a potential sources of
danger.

Before connecting the machine to power supply,
make certain that the rating plate corresponds to
the requirements of the electrical grid.

The power cable must lie flat (avoid curling or
overlapping) in a position which is not exposed to
any impacts or handling by minors. It must not be
placed near liquids, water or heat sources, and
must not be damaged (if necessary have qualified
personnel replace it).

The use of adapters, multiple sockets and/or
extensions is not advised. Whenever their use is
absolutely necessary, only use products with
quality certification markings (IMQ, VDE, +S, etc.),
and ensure that the power rating stamp is higher
than the absorption (A = amps) of the equipment to
be attached.

In the event of doubt or uncertainty, have qualified
personnel check the electrical power supply which
must correspond to the provisions required by the
current safety regulations, including:
o
Proper earthing;
o
Conductor section is suitable for the absorption
capacity;
o
Efficient residual current device.

Position the machine on a hydro-repellent surface
(laminated, stainless steel, ceramic, etc.) away from
heat sources (ovens, stove tops, fireplaces, etc.)
and in an environment where temperature does
not drop below +5 °C.

Do not expose the machine to the elements, or
install it in an environment with high humidity,
such as a bathroom area.

If the need for a replacement part arises, contact a
distributor or Authorised Retailer and only used
original spare parts.

The machine in its packaging is to be stored in a dry
location, free from humidity and protected from
the elements. The temperature must not be lower
than +5 °C.
A maximum of four packages containing
pieces of the same type may be stacked, one
on top of the other. Do not stack heavy
packages on boxes of a different type. In the
event of damage to objects or persons caused by the
improper installation or use, the manufacturer can not
be considered responsible.
Rev.05