Hama EWS-870 Bedienungsanleitung Seite 7

5.1. Base station
• Use the base to position the base station on a level surface.
5.2. Measuring station
• You can also position the measuring station on a level outdoor surface.
• We recommend installing the measuring station securely on an outdoor wall
using the opening (19).
• Install an anchor, screw, nail, etc. in the wall of your choice.
• Hang the measuring station using the opening intended for this purpose (19).
6. Operation
Note – Input
Hold down the CH+ button (10) or the MEM– button (14) to select the values faster.
6.1. Connection to the measuring station
• After you insert the batteries, the base station automatically searches for a connection to the
measuring station and performs initial setup.
Note
• Initial setup takes approx. 5 minutes.
• During connection, the wireless symbol on the measuring station will flash (5).
• Do not press any buttons during setup. Otherwise, values may not be transmitted correctly and
there is a risk of value errors and inaccuracies.
• The setup process is completed when the indoor (7) and outdoor (6) measurement data is
displayed.
• If the base station still does not receive a signal from the measuring station, press the SENSOR
button (12) to start the manual search for the signal. During the connection attempt, the
measuring station radio symbol (5) will flash.
• During the manual search, press and hold the SENSOR button (12) for approx. 3 seconds to end
the search. The radio symbol (4) disappears.
6