Hama EWS-870 Bedienungsanleitung Seite 10

Manually setting
• Press and hold the DISPLAY SET button (13) for approx. 3 seconds
to make the following settings one after the other:
• 12/24-hour format (1)
• Hours (1)
• Minutes (1)
• Seconds (only zeros possible) (1)
• Time zone (1)
• To select the individual values, press the CH+ button (10) or the MEM– button (14) and confirm
each selection by pressing the DISPLAY SET button (13).
• If you do not make an entry for 60 seconds, you automatically exit the setup mode.
Note – Time zone
• The DCF signal can be received over long distances, but always transmits the current Central
European Time in Germany. Make sure you account for the time difference in countries with
another time zone.
• If you are in Moscow, the time is 3 hours later than in Germany. This means that you should set
+3 for the time zone. The clock then automatically sets the time to 3 hours after the DCF signal
received or relative to the manually set time.
Alarm
• Press and hold the ALARM SET button (9) for approx. 3 seconds to set the time of the alarm
displayed. The hours display begins to flash.
• Press the CH+ button (10) or the MEM– button (14) to select the hour for the alarm time and
confirm your selection by pressing the ALARM SET button (9). The minutes display begins to flash.
• Repeat the process to set the minutes for the alarm time.
• If you do not make an entry for 60 seconds, you automatically exit the setup mode.
• The alarm function is automatically activated when you set the alarm time.
• Alternatively, you can press the ALARM SET button (9) to display the alarm time (AL).
• Press the ALARM SET button (9) as needed to activate/deactivate the alarm.
• The alarm symbol (3) will either be displayed or not displayed accordingly.
• When the alarm is triggered, the alarm symbol (3) begins to flash and an alarm sounds.
• Press the ALARM SET button (9) to stop the alarm. Otherwise, it will stop automatically after 2
minutes.
9