Handling And Operation; Switching The Device On And Off; Heating Operation - Silvercrest SWW 1500 A1 Bedienungsanleitung

Assembly/Handling and operation
♦ Remove the device from the wall again. With an electric drill and an 8 mm
drill bit drill the hole to a depth of, at least, 40 mm, subsequently insert the
rawlplug into the hole.
♦ Hang the device on the wall and tighten the screw with the angle bracket
(see diagram Tightening the angle bracket).
Diagram Tightening the angle bracket
♦ Insert the power plug into a mains wall socket.

Handling and operation

NOTICE
► All functions can be switched both with the buttons on the device and with
the remote control.
In this section you receive important information for the handling and operation
of the device.
Switching the device on and off
With the main switch POWER
mains power.
♦ Firstly switch the main switch POWER
no longer operating the device.

Heating operation

♦ Activate the main switch POWER
appears briefl y
area of the integrated temperature sensor. The device is now in standby
mode. In the display
♦ Press the button POWER/MODE
with the low heat output (LOW). In the display
♦ Press the button POWER/MODE
output (HIGH). In the display
SWW 1500 A1
the device is completely disconnected from the
6
on and/or lastly off when you are
6
to switch the device on. In the display
6
and subsequently the current device temperature in the
the symbol for the frost protection function
3 and/or
3 and/or
appears .
D
. The device switches on
12
appears .
again to set the high heat
12
GB
D
blinks.
11