Silvercrest SWW 1500 A1 Bedienungsanleitung Seite 12

GB
10
♦ Slide the upper wall brackets
rear panel and fi rmly screw these, together with the angle bracket
the lower wall brackets
use the 7 screws M4 x 13 mm (see diagram Wall bracket assembly).
B
B
Diagram Wall bracket assembly
♦ Mark two drill holes at a height of 600-650 mm and at a distance of 330 mm.
♦ Mark two more drill holes at a height of 250-300 mm and at a distance of
330 mm. Make sure that the distance between the upper and lower drill
holes is 350 mm (see diagram Drill scheme).
♦ Now with an electric drill and an 8 mm drill bit drill four holes to a depth of,
at least, 40 mm.
350 mm
600 mm - 650 mm
Diagram Drilling scheme
♦ Insert the rawlplugs into the holes and screw in the M4 x 42 screws.
Allow the screw heads to stick out slightly.
♦ Now hang the device on the screws and mark the drill hole for the angle
bracket .
D
into the holding fi xtures
B
, to the rear panel of the device. For this purpose
B
B
D
330 mm
Assembly
C on the device's
and
D
C
ø 8 mm, 40 mm
250 mm - 300 mm
SWW 1500 A1