Herunterladen Diese Seite drucken

Troubleshooting - SUNTEC Klimatronic Progress 7.0 plus Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für Klimatronic Progress 7.0 plus:

Werbung

will drain outside. The unit can also work well.
Installation Explanations
A removal air-conditioner shall be installed in the flat and empty place all around.
-
Don't block the air outlet, and the required distance around should be at least 30cm.
The unit should not be installed in dry-cleaner.
-
Introduction to Exhaust Hose Installation
A) Temporary installation
1.
Twist both ends of the exhaust hose into the square fixing clip and the flat
fixing clip.
2.
Insert the square fixing clip into openings at back of the local air conditioner.
Hook the left side of the adapter into the opening at the rear cover. Conduct
the right side at the rear cover
engages.
3.
Put the other end of the exhaust hose to the near windowsill.
Maintenance Explanations
Declaration:
1) Before cleaning, be sure to disconnect the unit from any electric supply outlet;
2) Do not use gasoline or other chemicals to clean the unit;
3) Do not wash the unit directly;
4) If the conditioner is damaged, please contact the dealer or repair shop.
1. Air Filter
If the air filter becomes clogged with dust/dirt, the air filter should be cleaned once
-
every two weeks.
Dismounting
-
Open the air inlet grille and take off air filter.
Cleaning
-
Clean the air filter with neural detergent in lukewarm(40°C)and dry it up in the shade.
Mounting
-
Putting the air filter into the inlet grille, replace the components as they were.
-
Clean the Air-conditioner Surface
First clean the surface with a neutral detergent and wet cloth, and then wipe it with a dry cloth.

Troubleshooting

Troubles
Unit does not start when pressing
POWER
button
Not cool enough
and press it down until the Adapter
Possible Causes
- Water full indicator lamp blinks, and
water tank is full.
- Room temperature is higher than the
setting temperature. (Electric heating
mode)
- Room temperature is lower than the
setting temperature. (Cooling mode)
- The doors or windows are not
closed.
Suggested Remedies
Dump the water out of the water tank.
Reset the temperature
Reset the temperature
Make sure all the windows and doors
are closed.
20

Werbung

loading