Troubleshooting - SUNTEC KLIMATRONIC Motion plus Bedienungsanleitung

4) Surface cleaning
Clean the unit using a damp cloth, and then wipe it using a dry cloth. Do not use chemical solvents (such as
gasoline, alcohol). The surface and the entire housing could be damaged.
5) Air filter cleaning
Clean the air filter regularly. If the air filter is clogged with dust, the efficiency of the device could be reduced.
1) Open the air outlet and remove the filter.
2) Wash the air filter by submersion into warm water (about 40° C) with neutral detergent, rinse it under running
water and dry it with a soft cloth.
3) Install air filter carefully after cleaning and drying.
Storage
1. Pull the power plug and empty the water tank. Then set the device into the operating mode. Press the fan
button and hold it for a. 5 seconds until the device switches to low fan speed. Let the unit run in this mode for half
a day until the inner construction has dried. Thus, it will not become mouldy.
2. Turn off the unit and unplug the power cord.
3. Coil the cord and attach it to the holder.
4. Disconnect the exhaust tubing from the device and keep it safe.
5. Put the unit into a box and bring it to a dry place.
6. Remove the batteries from the remote control and keep them safe as well.

Troubleshooting

Don't repair or disassemble the unit by yourself, unsuitable repair may make the quality-protected card in vain,
and even cause damage to the user or his/her possession.
Problems
1. The unit does not
turn on when you
press the Power
button.
2. The unit does not
cool properly.
3. The unit switches
off automatically.
4. Noise
5. E0 error
6. E2 error
Cause
Power cord is not plugged.
Water full indicator lamp blinks.
Room temperature is higher or
lower than the adjusted
temperature.
Windows and doors are open.
Another heat source in the room.
Exhaust hose is disconnected or
blocked.
The adjusted temperature is too
high.
Air inlet is blocked by smth.
Overheat protection
switches off automatically when the
temperature at the
exceeds 70° C).
The unit is not on a flat surface.
You hear refrigerant flowing.
This error message indicates too
high ambient temperature. Please
observe the instructions for the
optimal operation of your MOTION
unit. It can also be a temporary error
measurement between the input
and the output temperature.
Water tank is full.
Solution
Insert the plug into the socket and turn on the unit.
Empty the water tank.
Reset the temperature adjustment.
Close all windows and doors.
Remove the heat source.
Connect or clean exhaust hose.
Reset temperature adjustment, set the desirable
temperature (16° C-31° C)
Clean the blocked place.
(the unit Restart the unit and adjust lower temperature.
air outlet
Place the unit on a hard flat surface (reduces noise).
That is normal.
In this case turn off the unit and restart it after
30 minutes again. If the error occurs for long, the unit
must be checked by your dealer.
Empty the water tank.
17