Troubleshooting - SUNTEC KLIMATRONIC FUSION plus Bedienungsanleitung

Water drainage
1.Manual drainage :
1.1 When water tank is full and unit stop working, please shut off the unit and unplug
Please don't move the model sharply, or the water will spilt out from water received plate.
1.2 Use a water container to take water under the water plug.
1.3 Screw off the water plug and unplug the water blocker, water will come out to the water container.
2. Continue drainage:
2.1 Screw off the water plug and unplug the water blocker.
2.2 Use water pipe to connect the water outlet. Lead the pipe to the outside or washroom.
Remark: 1.This method can be done only if there is no water in the water received plate.
2.3This model have self evaporative function, under cooling mode, please don't use continue drainage to get
better cooling effect.
Cleaning
Please shut off the unit and unplug the plug before cleaning or maintenance
Clean the surface
Clean the housing with a duster or a soft wet cloth. Do not use chemical
solvent (such as benzene, alcohol, gasoline). The surface may be
damaged or even the whole case may be deformed.
1. Air filter cleaning
1.1Clean the air filters every 2 weeks. If the air filter is blocked with dust,
the efficiency will reduce.
1) Pull out up and down filter as below pictures
2) Wash the air filters by immersing it gently into warm (about 40℃) water
with a neutral detergent, rinse it and dry it thoroughly in a shaded place。
3) Install air filters carefully after cleaning the filters.
Storage
1. Pull out the plug in drainage hole and empty the water-received plate, or drain out the water by leaning the unit,
then shift the unit mode to Fan mode, and press the button for 5 seconds till it to low fan speed. Keep this mode for
half day till the conduit is dried. Doing like this can keep the inner unit dried and not go moldy.
2. Turn off the unit and pull out the plug.
3. Coil the wire and bind it together, then put it into the accessories room.
4. Separate the air-exhausted pipe and safely keep it.
5. Put the unit into a plastic bag, then keep it in a dried place.
6. Take out the batteries of remote control and safely keep them.
Trouble Shooting
Don't repair or disassemble the unit by yourself, unsuitable repair may make the quality-protected card in vain,
and even cause damage to the user or his/her possession.
.
Trouble
The unit doesn't
work
The unit does not
seem to perform.
The unit noise is
high
Compressor
doesn't work
Reason
No power supply
Water-full indicator illuminate
Timer function is active
Room temperature too low or too
high?
In direct sunlight
Windows or doors open, many
people or a heat source in the room
Filter is very dirty
Air inlet or air outlet is blocked
Room temperature is lower than
setting temperature
The unit is not put on flat place
Heat-exceeded protection is
active
Solution
Power-on and turn on the unit.
Drain out the inner stored water
Cancel Timer function
Suggesting ambient temperature between 7-40℃
Draw the curtains
Close windows and turn on another local air
conditioner
Clean or change the air filter
Clear out the stemming
Change the setting temperature
Put the unit on flat and hard place( reduce noise)
Re-start the unit 3 minutes later till the temperature
low down.