SUNTEC Klimatronic Progress 7.0 plus Bedienungsanleitung Seite 18

Operation Display, Figure 4
1. Auto Mode Icon
2. Fan Speed
3. Cooling Mode
4. Temp. and Timer Setting
5. Timer on
6. Temperature °C
7. Dry Mode Icon
Appearance and Function of Remote Controller, Figure 5
21. POWER Button; press this button will turn the machine on or off
22. Temperature setting button; this button is used to set the room temperature.
Each key press increases the room temperature about 1°C.
23. Speed Button; Press this button will choose high, middle or low ventilation
speed.
24. Timer button; press to set the timer on or off
25. Temperature setting button; this button is used to set the room temperature.
Each key press reduces the room temperature about 1°C.
26. Mode Button; press this button will choose the function auto cooling, cooling,
or dry.
Operation Introduction, Figure 6
Before starting operations in this section:
1. Find a place where there is power supply nearby.
2. As shown in the figure on the right, install the exhaust hose, and adjust the window position well.
3. Insert the power cord into an grounded AC220-240V/50Hz socket;
4. Press the POWER button to turn on the air-conditioner.
5. After switching on, or over, the ventilator operates, but the compressor starts later. Cooling effect may
require a further 10 minutes.
Before using
Notice:
1. Operation temperature range:
Check up whether the exhaust hose has been mounted properly.
Cautions for cooling and dehumidifying operations:
When using functions on cooling and dehumidifying, keep an interval of at least 3 minutes between turning on
-
and turning off.
Power supply meets the requirements.
-
- The socket is for AC use.
- Do not share one socket with other appliances.
Power supply is AC220-240V，50Hz
-
2. Cooling operation
Press the "Mode" button till the "Cool" icon (see Figure 4) appears.
-
18