What To Do If - IKEA FULLSTÄNDIG Montageanleitung

ENGLISH

What to do if ...

Problem
The appliance does not
work
The hood's suction level is
not enough
The light does not work
Before contacting the Authorized Service
Centre:
Switch the appliance on again to see if the
problem has disappeared. If not, switch it off
again and repeat the operation after an hour.
If your appliance still does not work properly
after carrying out the checks listed in the
troubleshooting guide and switching the
appliance on again, contact the Authorized
Service Centre, clearly explaining the problem
Possible cause
There is no mains
electrical power
The appliance is not
connected to the electrical
supply
The suction speed is too
low
The grease filters are
dirty 4
The anti-odors filters are
dirty
The air vents ar e
obstructed
The LED is broken 2
Solution
Check for the presence of mains electrical
power.
Turn off the appliance and restart it to see
if the faults persists.
Check if the appliance is connected to the
electrical supply.
Turn off the appliance and restart it to see
if the faults persists.
Check the suction speed and adjust as
necessary.
Check that the filters are clean
If not, clean the filters in the dishwasher.
Check that the anti-odour filters are
properly washed as recommended
Check the air vents for any obstructions
and remove as necessary.
For replacement, contact the Authorized
Service Centre.
and specifying:
• the type of fault;
• the model;
• the type and serial number of the appliance
(given on the rating plate);
• the Service number (the number after the
word SERVICE on the rating plate inside the
appliance).
10