What To Do If - IKEA LUFTIG HW400 Handbuch

http://ikea-club.com.ua
ENGLISH

What to do if ...

Problem
The appliance does not work
The hood's suction level is not
enough
The light does not work
Before contacting the After-sales service:
Switch the appliance on again to see if the
problem has disappeared. If not, switch it
off again and repeat the operation after an
hour.
If your appliance still does not work properly
after carrying out the checks listed in the
troubleshooting guide and switching the
appliance on again, contact the After-sales
service, clearly explaining the problem and
specifying:
Possible cause Solution
There is no mains Check for the presence of
electrical power mains electrical power.
Turn off the appliance and
restart it to see if the faults
persists.
The appliance is not Check if the appliance is
connected to the connected to the electrical
electrical supply supply.
Turn off the appliance and
restart it to see if the faults
persists.
The suction speed is too Check the suction speed and
low adjust as necessary.
The metal fi lters are Check that the fi lters are clean
dirty If not, clean the fi lters in the
dishwasher.
The air vents are Check the air vents for any
obstructed obstructions and remove as
necessary.
The light bulb is broken Check the light bulb and
replace it if necessary.
The light bulb is not Check that the light bulb has
correctly fi tted been correctly fi tted.
If not, fi t the light bulb in right
way.
• the type of fault;
• the model;
• the type and serial number of the
appliance (given on the rating plate);
• the Service number (the number after the
word SERVICE on the rating plate inside
the appliance).
9