What To Do If - IKEA FÖLJANDE 10392192 Bedienungsanleitung

ENGLISH

What to do if ...

Problem
The appliance does not
work
The hood's suction level
is not enough
The light does not work
Before contacting the Authorized Service
Centre:
Switch the appliance on again to see if the
problem has disappeared. If not, switch it
off again and repeat the operation after an
hour.
If your appliance still does not work properly
after carrying out the checks listed in the
troubleshooting guide and switching the
appliance on again, contact the Authorized
Service Centre, clearly explaining the
problem and specifying:
Possible cause
There is no mains
electrical power
The appliance is not
connected to the
electrical supply
The suction speed is
too low
The metal filters are
dirty
The air vents are
obstructed
The LED is broken
The BULB is broken
The light bulb is not
correctly fitted
Solution
Check for the presence of mains
electrical power.
Turn off the appliance and restart it to
see if the faults persists.
Check if the appliance is connected to
the electrical supply.
Turn off the appliance and restart it to
see if the faults persists.
Check the suction speed and adjust as
necessary.
Check that the filters are clean
If not, clean the filters in the
dishwasher.
Check the air vents for any
obstructions and remove as necessary.
For replacement, contact the
Authorized Service Centre.
Check the light bulb and replace it if
necessary.
Check that the light bulb has been
correctly fitted. If not, fit the light bulb
in right way.
• the type of fault;
• the model;
• the type and serial number of the
appliance (given on the rating plate);
• the Service number (the number after
the word SERVICE on the rating plate
inside the appliance).
10