Settings In Practice - Tunze 7097 Gebrauchsanleitung

Settings in practice

Before first use, please check the proper attachment of the pumps / Wavebox in the aquarium!
Position the pumps in the aquarium in such a manner, that the settings do not cause any water damages on the
Multicontroller due to strong current!
Prior to the adjustment, we recommend a synchronization of the Multicontroller 7097 time with the computer. For this,
click on the "light control" field, and in the field "real time clock" click on the "sync with PC" button. The real time in the
computer is now displayed in this field.
pulse only" – wave motion simulation
"
The pulse operation generates biologically active current pulses (= waves) which simulate a natural wave motion.
The greater the difference between the specified pump performances, the greater the wave character of the current
flow will be.
In the field of "mode", click on the "pulse only" button.
In the field "power control", the pump performance can be set to "low power" and "high power" by clicking on "channel"
in the channels 1 to 4. The number zero "0" means pump not operating. The lowest possible setting is 20%, and the
maximum adjustable setting is 100%.
The pulse frequency "pulse flow" can be set from 0.3 to 8.0 sec. This pulse frequency is very accurate, and can also
function as a Wavebox controller (Wavecontroller).
Ramping function (swelling): the "ramp" setting can be used to program a soft start of the pumps (reduces the pumps
sounds). The ramp time cannot be selected greater than the "pulse flow" time.
Surf current flow "random flow": a clicking will cancel the setting "pulse flow", and the pumps will function according
to a random variable pulse operation between 0.5 and 3.5 seconds to reproduce a typical surf.
Up to four pumps can be connected directly. With two Y-adapter cables 7090.300 an extension up to eight pumps
will be possible.
94 95