Tunze 7097 Gebrauchsanleitung Seite 38

1
3
6
9
10
7
8
74
2
11
12
13
Software update for Multicontroller 7097
To update the software of the Multicontroller 7097, it is necessary to use the "Updater FLIP" application provided by
the chip manufacturer Atmel
package (1).
4
When your device is connected to the computer, the previous/current version number will be displayed in the program
of the Multicontroller 7097 on the top right of the user interface (2). When a new version is available you can determine
this based on the version number, and update the software as needed.
5
New versions are not automatically updated by the device itself, but must rather be downloaded from www.tunze.com/
download/software-download.
Install the JavaRuntime from the software package to update the 7097. For this, please follow the application's
installation routine.
Afterwards, please install "FLIP" which is also included in the package on your computer.
Save the file from the sub-item "Open Update File" on the desktop (3).
Press and hold the Food-timer button (4) of the powered-down Multicontroller 7097, and connect it to the computer via
the USB cable (5). Now release the Food-timer button and open the program "FLIP".
Press the "Select a target device" button (6). There, select "ATMEGA32U4" (7) from the menu and open it (8). Click on
the "Select a communication medium" (9) button, and there on USB. Then select the update file stored on the desktop
under "File" (10) / "Load HEX file" (11). Now click on the "Run" button (12). After the successful update, "Verify pass"
can be read on the bottom left (13). Now, the Multicontroller 7097 is ready for use with the new software.
. This will be included with each update. The version number will be displayed in the
®
75