Setting Down And Storing The Vacuum Cleaner; Maintenance - Miele Swing H01 Gebrauchsanweisung

Please observe the flooring manu‐
facturer's cleaning and care instruc‐
tions.
This hard floorbrush is especially suita‐
ble for vacuuming floors with deep
gaps and crevices, e.g. old wooden
flooring.
To adjust the floorhead (dia. 15 + 16)
This vacuum cleaner can be used for
daily cleaning of carpets, rugs and ro‐
bust hard flooring.
Miele offer a range of other floorheads,
brushes and accessories for other
types of flooring and special require‐
ments (see "Optional accessories").
Please observe the flooring manufac‐
turer's cleaning and care instructions.
Vacuum carpets and rugs with the
brush retracted:
 Press the  foot control.
Clean hard flooring which is not sus‐
ceptible to scratching, as well as floor‐
ing with gaps or deep crevices in it with
the brush protruding:
 Press the  foot control.
Setting down and storing the
vacuum cleaner
There is a non-slip end cap on the han‐
dle. The vacuum cleaner can be leaned
upright against a wall or furniture during
pauses in vacuuming or when storing it
(dia. 17).
Before leaving the vacuum cleaner
make sure it is switched off and if you
lean it against a wall make sure it is at
a safe angle so that it cannot fall over.
When using a floorbrush we recom‐
mend that you hang the vacuum
cleaner up when storing it to protect
the bristles.
For longer term storage, the vacuum
cleaner can also be hung on a wall
hook using the hook on the handle (dia.
18).

Maintenance


Always disconnect the vacuum
cleaner from the electrical supply for
maintenance work and for cleaning.
Switch off at the wall socket and un‐
plug it.
The Miele filtration system consists of
three components (dia. 19):
 Dustbag
 Dust compartment filter (for motor
protection)
 Exhaust filter
These will need to be replaced from
time to time to ensure that your vacuum
cleaner performs efficiently.
en
37