Setting Down And Storing The Cleaner; Maintenance - Miele HS07 Gebrauchsanweisung

Clean hard flooring which is not
susceptible to scratching, as well as
flooring with gaps or deep crevices in it
with the brush protruding:
^ Press the ) foot control.
AirTeQ floorhead (dia. 16)
If the suction power of the AirTeQ
floorhead seems too high, select the
min. setting.
Setting down and storing the
cleaner
There is a non-slip end cap on the
handle. The vacuum cleaner can be
leaned upright against a wall or
furniture during pauses in vacuuming or
when storing it (dia. 17).
Before leaving the vacuum cleaner
make sure it is switched off and if
you lean it against a wall make sure
it is at a safe angle so that it cannot
fall over.
When using a floor brush we
recommend that you hang the
vacuum cleaner up when storing it to
protect the bristles.
For longer term storage, the vacuum
cleaner can also be hung on a wall hook
using the hook on the handle (dia. 18).

Maintenance

,
Always disconnect the vacuum
cleaner from the electrical supply for
maintenance work and for cleaning.
Switch off at the wall socket and
unplug it.
The Miele filtration system consists of
three filters (dia.19).
a Dustbag
b Dust compartment filter (for motor
protection)
c Exhaust filter
These will need to be replaced from
time to time to ensure that your vacuum
cleaner performs efficiently.
Only use genuine dustbags, filters
and accessories with the "Original
Miele" logo on them. This will ensure
that the suction power of the
vacuum cleaner is maintained,
giving the best possible cleaning
results.
,
The use of dustbags made from
paper or paper-based materials,
or dustbags with a cardboard collar,
or dustbags that do not carry the
"Original Miele" logo, can seriously
damage the vacuum cleaner and
invalidate the warranty.
en
33