Declaration Of Conformity; Dust/Chip Extraction - Bosch GDA 280 E Professional Originalbetriebsanleitung

OBJ_BUCH-428-001.book Page 17 Monday, July 2, 2007 10:58 AM
Note: To be accurate, an estimation of the level
of exposure to vibration experienced during a giv-
en period of work should also take into account
the times when the tool is switched off and when
it is running but not actually doing the job. This
may significantly reduce the exposure level over
the total working period.

Declaration of Conformity

We declare under our sole responsibility that the
product described under "Technical Data" is in
conformity with the following standards or
standardization documents: EN 60745 according
to the provisions of the directives 89/336/EEC,
98/37/EC (until Dec. 28, 2009), 2006/42/EG
(from Dec. 29, 2009 on).
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Head of Product
Engineering Certification
06.06.2007, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Assembly
Before any work on the machine itself, pull
the mains plug.

Dust/Chip Extraction

Avoid touching or breathing-in dusts that are
harmful to one's health or carcinogenic. Al-
ways use suitable dust extraction, work in
well ventilated areas and wear appropriate
protective equipment. When disposing of
dusts, pay attention that you or other per-
sons do not come into contact with these
dusts. Dusts dangerous to one's health devel-
op, e.g., when sanding lead-containing coat-
ings, chemically treated woods or some met-
als.
Bosch Power Tools
External Dust Extraction (see figure A)
Attach a vacuum hose 7 onto the outlet piece 3.
Connect the vacuum hose 7 with a vacuum clean-
er. An overview for connecting to various vacuum
cleaners can be found at the beginning of these
operating instructions.
The vacuum cleaner must be suitable for the ma-
terial being worked.
When vacuuming dry dust that is especially detri-
mental to health or carcinogenic, use a special
vacuum cleaner.
Replacing the Sanding Sheet
(see figure B)
When attaching a new sanding sheet, remove any
dust or debris from the sanding plate 5 (e. g. with
a brush).
To ensure optimum dust extraction, pay atten-
tion that the punched holes in the sanding sheet
match with the holes in the sanding plate.
The sanding plate 5 is fitted with Velcro backing
for quick and easy fastening of sanding sheets
with Velcro adhesion.
Before attaching the sanding sheet 4, free the
Velcro backing of the sanding plate 5 from any
debris by tapping against it in order to enable op-
timum adhesion.
Position the sanding sheet 4 flush alongside one
edge of the sanding plate 5, then lay the sanding
sheet onto the sanding plate and press it against
it with a light turning motion in clockwise direc-
tion.
To remove the sanding sheet 4, grasp it at one of
the tips and pull it off from the sanding plate 5.
Sanding accessories, such as fleece pads/polish-
ing cloth pads, are attached to the sanding plate
in the same manner.
English | 17
2 609 932 592 | (2.7.07)