Maintenance And Service; Maintenance And Cleaning - Bosch GDA 280 E Professional Originalbetriebsanleitung

OBJ_BUCH-428-001.book Page 19 Monday, July 2, 2007 10:58 AM
Preselecting the Orbital Stroke Rate
With the thumbwheel for preselection of the or-
bital stroke rate 2, you can preselect the required
orbital stroke rate, even during operation.
The required stroke rate depends on the material
and the working conditions and can be deter-
mined through practical testing.
Operating Instructions
Wait until the machine has come to a stand-
still before placing it down.
The removal capacity during sanding is mainly de-
termined by the selection of the sanding sheet as
well as the preselected orbital stroke rate.
Only flawless sanding sheets achieve good sand-
ing capacity and extend the service life of the ma-
chine.
Pay attention to apply uniform sanding pressure;
this increases the working life of the sanding
sheets.
Intensifiying the sanding pressure does not lead
to an increase of the sanding capacity, but to in-
creased wear of the machine and the sanding
sheet.
For precise on-the-spot sanding of edges, cor-
ners and hard to reach areas, it is also possible
to work only with the tip or an edge of the sand-
ing plate.
A sanding sheet that has been used for metal
should not be used for other materials.
Use only original Bosch sanding accessories.

Maintenance and Service

Maintenance and Cleaning

Before any work on the machine itself, pull
the mains plug.
For safe and proper working, always keep
the machine and ventilation slots clean.
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for Bosch power tools.
Bosch Power Tools
In all correspondence and spare parts order,
please always include the 10-digit article number
given on the type plate of the machine.
WARNING! Important instructions for connect-
ing a new 3-pin plug to the 2-wire cable.
The wires in the cable are coloured according to
the following code:
Do not connect the blue or brown wire to the
earth terminal of the plug.
Important: If for any reason the moulded plug is
removed from the cable of this power tool, it
must be disposed of safely.
After-sales service and customer assist-
ance
Our after-sales service responds to your ques-
tions concerning maintenance and repair of your
product as well as spare parts. Exploded views
and information on spare parts can also be found
under:
www.bosch-pt.com
Our customer consultants answer your questions
concerning best buy, application and adjustment
of products and accessories.
Great Britain
Robert Bosch Ltd. (B.S.C.)
P.O. Box 98
Broadwater Park
North Orbital Road
Denham
Uxbridge
UB 9 5HJ
Tel. Service: +44 (0844) 736 0109
Fax: +44 (0844) 736 0146
E-Mail: SPT-Technical.de@de.bosch.com
English | 19
2 609 932 592 | (2.7.07)