Noise/Vibration Information; Declaration Of Conformity - Bosch GEX 125 A Professional Originalbetriebsanleitung

18 | English

Noise/Vibration Information

Measured values determined according to
EN 60745.
Typically the A-weighted sound pressure level of
the product is 75 dB(A). Uncertainty K=3 dB.
The noise level when working can exceed
80 dB(A).
Wear hearing protection!
Vibration total values (triax vector sum) deter-
mined according to EN 60745:
Vibration emission value a
tainty K =1.5 m/s
The vibration emission level given in this infor-
mation sheet has been measured in accordance
with a standardised test given in EN 60745 and
may be used to compare one tool with another.
It may be used for a preliminary assessment of
exposure.
The declared vibration emission level repre-
sents the main applications of the tool. However
if the tool is used for different applications, with
different accessories or poorly maintained, the
vibration emission may differ. This may signifi-
cantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibra-
tion should also take into account the times
when the tool is switched off or when it is run-
ning but not actually doing the job. This may sig-
nificantly reduce the exposure level over the to-
tal working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.
1 609 929 N98 | (13.11.08)
Downloaded from www.Manualslib.com
2
=4.0 m/s , Uncer-
h
2
.
manuals search engine

Declaration of Conformity

We declare under our sole responsibility that the
product described under "Technical Data" is in
conformity with the following standards or
standardization documents: EN 60745 according
to the provisions of the directives 2004/108/EC,
98/37/EC (until 28 Dec 2009), 2006/42/EC
(from 29 Dec 2009).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
23.09.2008
Assembly
Before any work on the machine itself, pull
the mains plug.
Replacing the Sanding Sheet
(see figure A)
When attaching a new sanding sheet, remove
any dust or debris from the sanding plate 8,
e. g., with a brush.
The surface of the sanding plate 8 is fitted with
Velcro backing for quick and easy fastening of
sanding sheets with Velcro adhesion.
Press the sanding sheet 9 firmly against the bot-
tom side of the sanding plate 8.
To ensure optimum dust extraction, pay atten-
tion that the punched holes in the sanding sheet
match with the holes in the sanding plate.
Dr. Eckerhard Strötgen
Head of Product
Certification
Bosch Power Tools