Sw Out Terminal - Sony SVT-L230P Bedienungsanleitung

Terminals
1
Press MENU until the SET UP 3 display appears
on the screen.
2
Press SHIFT $ to move the flashing to TAPE
END OUT and set to –3M or END by pressing
REC/PLAY SPEED +/–.
<SET UP 3>
ALARM MODE Y1
ALARM SPEED 6H
ALARM DURATION 20S
EXT TIME ADJ. 01:00
TAPE IN MODE STOP
TAPE END MODE REW
TAPE END OUT -3M
CLOG DETECT. Y
SERIES REC N
RS-232C 9600
3
Press SEARCH to return to the normal display.

SW OUT Terminal

The VCR outputs a pulse signal from the SW (switch)
OUT terminal to the camera switcher to control the
switching from camera to camera.
SW OUT terminal
Specify the interval between each pulse signal on the
SET UP 4 display. Also, set TIMING to FIELD or
FRAME depending on the specifications of the camera
switcher.
Available settings are:
• FIELD: 1, 2, 3, 4, 5, 10, 30, or 60 fields
• FRAME: 1, 2, 3, 4, 5, 10, 30, or 60 frames
1
Press MENU until the SET UP 4 display appears
on the screen.
<SET UP 4>
∗SW OUT
FIELD 01
TIMING FIELD
6H Y
<USED TIME>
01 of FIELD is flashing.
38
2
3
4
COM terminal
5
Set the interval by pressing REC/PLAY SPEED
+/– and press SHIFT z .
<SET UP 4>
∗SW OUT
FIELD 04
TIMING FIELD
6H Y
<USED TIME>
Set TIMING to FIELD or FRAME by pressing
REC/PLAY SPEED +/–.
<SET UP 4>
∗SW OUT
FRAME 04
TIMING FRAME
6H Y
<USED TIME>
VIDEO 00000H
When the TAPE switch is set to E-180:
Set 6H (6-hour mode) to Y (yes) or N (no) by
pressing REC/PLAY SPEED +/–.
Y (yes): a signal is output in the 6-hour mode
N (no): a signal is not output in the 6-hour mode
When the TAPE switch is set to E-240:
Set 8H (8-hour mode) to Y (yes) or N (no) by
pressing REC/PLAY SPEED +/–.
Y (yes): a signal is output in the 8-hour mode
N (no): a signal is not output in the 8-hour mode
When you have completed the settings, press
SEARCH until the normal display appears.