Setting The Mode At The End Of The Tape - Sony SVT-L230P Bedienungsanleitung

To clear the P indicator
MENU RESET
Press MENU RESET.
To clear the power interruption/moisture
condensation data
Press MENU until the POWER FAILURE/DEW
display appears and press MENU RESET with pointed
material.
Setting the Mode at the End of
the Tape
You can set the mode of the tape operation when the
tape comes to the end during recording using the SET
UP 3 display.
When the REPEAT REC switch is set to OFF
1
Press MENU until the SET UP 3 display appears
on the screen.
2
Set TAPE END MODE to REW, STOP or EJECT
by pressing REC/PLAY SPEED +/–.
<SET UP 3>
ALARM MODE Y1
ALARM SPEED 6H
ALARM DURATION 20S
EXT TIME ADJ. 01:00
TAPE IN MODE STOP
TAPE END MODE REW
TAPE END OUT -3M
CLOG DETECT. Y
SERIES REC N
RS-232C 9600
REW: when the tape comes to the end, the VCR
rewinds the tape automatically and enters stop
mode at the beginning of the tape.
STOP: when the tape comes to the end, the VCR
enters stop mode at once.
EJECT: when the tape comes to the end, the tape
is ejected at once.
3
Press SEARCH to return to the normal display.
When the tape reaches the end
The OFF indicator lights in the display window.
Press 6 EJECT, r REC, )
z PLAY to turn off the OFF indicator.
When the REPEAT REC switch is set to ON
Follows the steps 2 through 4 in "Recording on the
Same Cassette Repeatedly — Repeat Recording" on
page 17.
FF, 0 REW or
19