Terminals; Timer Out Terminal; Warning Out Terminal; End Out Terminal - Sony SVT-L230P Bedienungsanleitung

Terminals

TIMER OUT Terminal

The VCR outputs +12 V from the TIMER OUT
terminal according to the timer setting on the TIMER
SET display. The terminal outputs the signal even if
the timer recording mode is off (the TIMER button is
set to OFF).
COM terminal
TIMER OUT terminal
Timer starts.

WARNING OUT Terminal

This terminal will help you to know when something
wrong has happened to the VCR during recording.
The VCR outputs a pulse signal from WARNING
OUT terminal.
COM terminal
Tape recording stops.
Note
To turn the clog detection function off, set CLOG
DETECT to N (no) on the SET UP 3 display.
TIMER OUT terminal
12 V
0 V
Timer stops.
WARNING OUT terminal
5 V
0 V
To reset, press p STOP or
6 EJECT, if the clog detection
function works and the VCR
gives warning, otherwise, press
the reset button.

END OUT Terminal

When the VCR detects the tape end or the time counter
shows "5H57M" or "7H57M" (depending on the
setting of the TAPE switch) during recording, the
output level becomes 0 V DC. To resume the 5 V
output, press the operation button (6 EJECT, r REC,
FF, 0 REW or z PLAY, etc.).
)
END OUT
terminal
REC mode
Tape end Beginning of tape
Recording
Rewind
mode
Output
signal
REPEAT REC mode
Tape end
Recording Rewind
mode
Output
signal
2 sec.
Set TAPE END OUT to –3M or END on the SET UP 3
display.
• –3M: the time counter shows "5H57M" (three
minutes before the tape end when using E-180 tape)
or "7H57M" (three minutes before the tape end when
using E-240 tape) and a signal is output from the
END OUT terminal (recording will be continued to
the end of the tape).
• END: the VCR detects the tape end.
COM terminal
Press operation
button
Stop
5 V
0 V
Beginning of tape
Recording
5 V
0 V
37