Operating Elements; Before Commissioning - Kärcher BR 40/10 C Adv Bedienungsanleitung

1 Lock for fresh water reservoir
2 Switch for brush drive
3 Switch for detergent solution
4 Hose for detergent solution
5 Lint sieve (suction)
6 Lock of pushing handle
7 Release button for the transport wheel
8 Transport wheel *
9 Push handle
10 Strain relief clamp
11 Support of the transport wheel *
12 Clip
13 Fresh water tank
14 Dirt water reservoir
15 Scraper roller
16 Push-button for vacuum bar change
17 Float
18 Button for brush change
19 Chassis
20 Vacuum bar
21 Brushing rollers
22 Rotating handle for brush contact pres-
sure
23 Pedal to lower vacuum bar
24 Mains plug
25 Carrying handle for wastewater reser-
voir
26 Fresh water tank cover
* not included in the delivery with BR 40/10
C Classic

Operating elements

Before Commissioning

Installing the pushing handle
 Slide the upper slider half onto the low-
er slider half.
Caution
Risk of damage. Do not pinch the cable
during the installation.
 Align the borings (2 possible height ad-
justments).
 Connect the slider halves to the lock
screws, discs and star grips.
 Fasten the cable to the slider using
clips.
2
-
EN
Installing the transport wheels
With the BR 40/10 C Classic, the transport
wheels are not included in the delivery. An
attachment kit with transport wheels is list-
ed in the chapter "Accessories".
 Insert the transport wheel axles into the
borings on the appliance and lock them.
Installing the Brushes
The brushes must be installed before the
initial operation (see "Maintenance works").
Operation
Note
To take the brush drive out of operation, im-
mediately release brush drive switch.
11